Installation Help
How do I loosen the strap on the GenTent Inverter kit?
When installing or adjusting your GenTent Inverter Kit, you may find that you've tightened the ratchet strap down before fully positioning your angle braces. If you need to shift the frame but can’t due to strap tension; don’t worry. You don’t need ...
How do I remove the extender arms with the GenTent Inverter kit?
Removing the extender arms from your GenTent Inverter Kit is a simple process that requires just a few steps and a flathead screwdriver. This guide will walk you through how to safely separate the extenders from the corner brackets or other extender ...
What’s the right side to position the Refuel Door on a GenTent?
The GenTent refueling door is designed to be placed on the side of the generator farthest from the exhaust muffler to reduce the risk of fire. Since generator exhausts can be located on different sides, sometimes on the back or opposite the control ...
How Do I Install a GenTent on an Inverter with a High Vent or Exhaust?
If your inverter has a high-mounted exhaust, install the Angle Braces at different heights—higher on the exhaust side—to create a sloped canopy. This ensures proper exhaust ventilation beneath the canopy edge. Use Extender Arms as needed and route ...
How do I refuel my generator with the GenTent on?
You can refuel your generator without removing the GenTent — just use the built-in refueling flap. Look for the GenTent logo on the canopy; the flap is directly beneath it. To refuel safely: Turn off the generator and allow it to cool completely ...
How Close to the exhaust can I be with my GenTent Canopy?
Always place your GenTent canopy directly above the generator’s exhaust—not beside or below it. This ensures safe venting of heat and fumes, protects your equipment, and maintains safe operation. Use brackets or Extender Arms as needed for proper ...
Can I use a single GenTent to cover two smaller inverter generators?
Yes. GenTent canopies can safely protect two small inverter generators (typically 1,000–2,000 watts each) running in parallel under a single cover when used with the GenTent Inverter Extender Arms Kit. This kit expands the frame to create a stable, ...
What is the right way to install the frame rods?
GenTent’s fiberglass frame rods form a durable, weather-resistant canopy structure over portable generators. To install them safely, never let rods snap back and avoid forcing them into position. Improper setup may cause sagging, water pooling, or ...
Do I have to drill into the frame?
No—most generators no longer require drilling thanks to our 2024 clamp upgrades, which fit round and square frames. If your model needs an adapter that requires a simple 5/32″ pilot hole and screws, our Fit Finder will let you know up front. Go to ...
Where should the apron be placed?
The apron should be attached to the Velcro strip at the base of the tent. Position the apron so that it covers the side of the generator with the electronics, ensuring they are protected from the elements. Be sure not to connect the apron to the ...
How should frame rods be seated?
Make sure your frame rods are fully seated in the connector so they don't break due to excess tension! While our fiberglass frame rods are strong, it is important to make sure they're properly inserted into the center connector so that when they're ...